Tankless Water Heater
Tankless Water Heater Installation & Replacement in Tempe, AZ
Solving Tankless Water Heater Failures in Your Tempe Home
Are you tired of stepping into a shower that suddenly turns freezing cold, dealing with a noticeable drop in hot water pressure, or constantly resetting a flashing error code on your current tankless unit? When a tankless water heater starts acting up, it rarely resolves itself because severe mineral buildup inside the heat exchanger forces the unit to work harder, eventually frying internal components or causing the metal to crack. The team at Gold Star Plumbing & Drain is ready to evaluate your current setup, diagnose the exact point of failure, and install a high-efficiency system tailored to your household's actual hot water demands.
Signs You Need a Tankless Water Heater Replacement
Dropping Hot Water Pressure
You turn on the shower or kitchen sink and notice the water flow is noticeably weaker when set to hot, but returns to normal high pressure when switched to cold. Because tankless units heat water by passing it through a series of narrow pipes, any restriction in those pipes immediately slows down the flow to your fixtures. This frustrating drop in pressure is almost always caused by severe limescale buildup choking the heat exchanger inside the unit.
If ignored, the unit will continue to overheat as it struggles to push water through the blockage. The system is essentially suffocating, which eventually burns out the heating elements or cracks the heat exchanger entirely. When the internal pathways become completely calcified, a full tankless water heater replacement is usually the only viable option.
The Cold Water Sandwich
You get a blast of hot water, followed by a sudden burst of freezing cold water, and then a return to hot water a few seconds later. This highly uncomfortable experience indicates a failing flow sensor or a dangerous ignition delay within the system. The unit is failing to recognize immediately that a hot water tap has been opened, causing a massive gap in the heating process.
This symptom usually worsens over time until the unit fails to ignite at all, leaving you with completely cold water when you need it most. Flow sensors can sometimes be cleaned, but if the issue stems from a damaged computer board or a failing burner assembly, the repair costs often outweigh the value of the unit. We handle this by thoroughly testing the ignition sequence to determine if a new system is the most cost-effective route for your home.
Persistent Digital Error Codes
Your unit’s digital display is constantly blinking with an error code, and resetting the machine only provides a temporary fix before the code returns. Modern tankless units are highly computerized and rely on a network of internal safety sensors to monitor performance. These codes are triggered when those sensors detect exhaust blockages, ignition failures, or dangerous temperature spikes inside the cabinet.
Constantly bypassing or resetting these codes without addressing the root cause can lead to catastrophic system failure, electrical damage, or even a severe gas hazard. When a unit is repeatedly throwing codes related to overheating or exhaust issues, it means the internal components are severely compromised. Replacing the unit ensures your home is protected by modern safety standards and reliable technology.
Water Pooling Beneath the Unit
You notice moisture, drips, or active puddles forming directly underneath your wall-mounted water heater. Unlike a traditional tank that might leak from a rusted bottom, a leaking tankless unit usually means a cracked heat exchanger or a blown internal valve. These ruptures are often the direct result of untreated hard water damage or excessive municipal water pressure stressing the internal piping.
Internal leaks are especially dangerous because they can quickly destroy the sensitive computer boards housed inside the casing. Once water reaches the electronics, the entire unit is rendered unrepairable and requires a full replacement. We assess the source of the leak immediately to prevent further damage to your drywall and surrounding property.
Why Your Tankless System is Failing
Severe Hard Water Scaling
Minerals dissolved in the municipal water supply literally bake onto the hot metal surfaces inside the water heater, forming a rock-hard layer of scale over time. Tempe has exceptionally hard water, making this the number one killer of tankless units in our local area. Without annual descaling flushes, the heat exchanger becomes heavily insulated by this calcium layer, destroying its ability to transfer heat to the water.
As the scale thickens, the burner has to run longer and hotter just to achieve the same water temperature, which rapidly degrades the metal components. The solution involves removing the ruined unit and installing a new, high-efficiency tankless system built to withstand local conditions. We also take the time to set up a proper maintenance plan to ensure your new investment does not suffer the same fate.
Undersized Gas Lines
The water heater cannot pull enough natural gas to ignite the burners fully, causing it to misfire, shut down, or underperform when multiple taps are running. Many older homes in the area were originally built for standard tank water heaters, which only require smaller half-inch gas lines to operate. When an inexperienced installer swaps in a tankless unit without upgrading the gas delivery, the new system essentially starves for fuel.
Tankless units require a massive amount of BTUs to heat water on demand, which almost always necessitates a three-quarter-inch gas line. Fixing this requires installing a correctly sized unit and ensuring the gas line is properly retrofitted to handle the high on-demand fuel requirements. We handle all the necessary gas line calculations and upgrades during the installation process so your new system operates flawlessly.
Improper Initial Sizing
The system simply cannot produce enough hot water to keep up with the demand of multiple showers, dishwashers, and washing machines running at the exact same time. This often becomes glaringly obvious during the colder months when the incoming municipal groundwater temperature drops significantly. The unit is forced to work much harder to raise that colder water to your desired output temperature, causing the flow rate to plummet.
An undersized unit will constantly run at maximum capacity, which drastically shortens its operational lifespan and leads to premature component failure. The solution is a professional flow-rate calculation and the installation of a tankless unit with the appropriate gallons per minute capacity for your specific household. We measure your exact hot water usage to guarantee your new system never leaves you waiting for a warm shower.
What to Expect During Your Tankless Installation Visit
Evaluating Your Hot Water Needs
When you schedule a tankless water heater installation & replacement, the process begins with a thorough evaluation of your home's current plumbing, electrical, and gas configurations. An expert technician will calculate your household's peak hot water demand to ensure the new unit is perfectly sized for your specific needs. We look at the number of bathrooms, the types of fixtures you use, and your daily routines to match you with the ideal system.
Removing the Old Unit and Upgrading Connections
Next, the old unit is safely disconnected, drained, and removed from your property. The installation area is prepped, which may include minor adjustments to your venting, gas lines, or water connections to ensure everything meets modern safety codes. The new tankless system is then securely wall-mounted, connected to your utilities, and carefully calibrated for optimal performance.
Final Testing and Calibration
Before leaving, the technician will test the system under full load to verify proper water pressure, precise temperature output, and flawless ignition. Gold Star Plumbing & Drain proudly serves the Tempe area, ensuring your new system is installed cleanly, safely, and correctly the very first time. We walk you through the operation of your new unit and explain exactly how to maintain it for years of reliable service.
Related Plumbing Upgrades for Your Home
To protect your new investment from the region's harsh mineral content, we highly recommend pairing your new unit with professional water softener installation & replacement. Removing the destructive calcium and magnesium before it ever reaches your water heater can easily double the lifespan of your tankless system. Additionally, our gas line installation & replacement services ensure your new system receives the exact fuel volume it needs to operate safely and efficiently.
The Cost of Ignoring Tankless Water Heater Issues
Rising Utility Bills and Inefficiency
Delaying a necessary tankless water heater replacement rarely saves you money in the long run. A unit struggling with severe scale buildup or failing internal components consumes significantly more gas and electricity to heat the same amount of water. This inefficiency drives up your monthly utility bills while providing a completely subpar hot water experience for your family.
The Risk of Sudden Ruptures
More importantly, pushing a failing heat exchanger past its limits can result in a sudden and catastrophic rupture. This not only destroys the unit entirely but can cause immediate water damage to your drywall, flooring, and nearby electrical systems. Addressing the warning signs early ensures you control the replacement timeline rather than facing an emergency shutoff and days without hot water.
Restoring Reliable Hot Water to Your Tempe Home
You shouldn't have to schedule your showers around your water heater's unpredictable behavior or worry about sudden temperature drops. Your daily routine relies on a consistent, safe, and efficient supply of hot water for bathing, cleaning, and cooking. Ignoring the warning signs only leads to more expensive repairs and the absolute inconvenience of a total system failure.
Our technicians have the hands-on expertise to remove your failing unit and install a premium system designed specifically for our local water conditions. Gold Star Plumbing & Drain is equipped with the knowledge and high-quality equipment needed to restore endless, reliable hot water to your home today. Reach out to our team right now to schedule your comprehensive tankless water heater assessment and installation.
Tell us what it is doing.
Submit your request and a member of the Gold Star team will call you as soon as possible to answer your questions and schedule your service. If water is moving right now, call instead. A person answers.
- East Valley (480) 571-5944
- Prescott (928) 813-0825
- Flagstaff (928) 691-4432
- Hours
- Open 24 hours, seven days
- Licence
- Arizona ROC 327327
Book a time online
The online scheduler is not available right now.
Or tell us what is going on
Request Your Service
Submit your request and a member of the Gold Star team will call you as soon as possible to answer your questions and schedule your service. Need help now? Call: emergency plumbers are dispatched 24/7.
Loading form. If it does not load, please use the other contact options on this page.
How we use your information: Privacy Policy · Your Privacy Choices