Skip to content
East Valley (480) 571-5944 · Northern AZ (928) 813-0825 · Open 24 hours, seven days. $300 off tankless water heater installation → · Finance now →

Tankless Water Heater

Tankless Water Heater Maintenance & Tune-Up in Cave Creek, AZ

Clearing Mineral Buildup and Restoring Performance: Tankless Water Heater Maintenance in Cave Creek

Are you noticing a frustrating drop in hot water pressure at your fixtures, experiencing sudden bursts of cold water during your shower, or seeing a flashing error code on your exterior wall-mounted unit? Tankless systems are fantastic for endless hot water, but when dissolved minerals from our local hard water flash-bake onto the narrow internal pathways, the unit has to burn hotter and work harder just to function. You do not have to wait for your system to lock you out entirely because Gold Star Plumbing & Drain is ready to professionally descale, clean, and tune up your unit today.

Warning Signs Your Tankless Water Heater Needs Immediate Maintenance

Flashing Error Codes on the Digital Display

Modern tankless water heaters are equipped with highly sensitive internal diagnostics that monitor every aspect of the heating process. When you see a blinking light or a specific number sequence like an LC or an 11 on the controller, the system is actively trying to tell you something is wrong. These codes frequently indicate scale buildup inside the heat exchanger, a blocked exhaust vent, or a dangerous ignition failure.

The system will intentionally lock itself out to prevent a catastrophic meltdown or a potential fire hazard. Resetting the unit by unplugging it from the wall will not fix the underlying physical blockage inside the pipes. Forcing a heavily scaled unit to run will eventually crack the heat exchanger, leading to internal flooding and a completely ruined system.

Noticeable Drop in Hot Water Pressure

You might notice that the cold water pressure at your kitchen sink or master bathroom shower is incredibly strong, but the moment you switch to pure hot water, the flow reduces to a weak stream. Tankless units utilize a small inline screen filter on the cold water inlet to catch debris, alongside very narrow internal copper pipes to rapidly heat the water. Over time, calcium buildup physically blocks the water from moving through these tight passages at its normal volume.

Low flow rates do more than just ruin your daily shower experience. They can actually drop the water volume below the unit's minimum activation threshold. If the flow rate is too low, the internal sensors will not tell the burner to ignite, leaving you standing under nothing but cold water.

The Cold Water Sandwich Effect

Few things are more startling than turning on the shower, enjoying the hot water, and suddenly getting blasted with ice-cold water for several seconds before it slowly heats up again. This frustrating phenomenon usually points to a fouled flow sensor or a heavily scaled heat exchanger that is struggling to read your home's water demand accurately. The unit shuts off the burner momentarily because it falsely assumes the water flow has stopped.

Once the system realizes water is still moving through the pipes, it frantically reignites the burner to catch up. Aside from being incredibly uncomfortable for you, this rapid on-and-off cycling puts immense wear and tear on the gas valve. Over time, this constant strain will prematurely wear out the igniter and the internal computer board.

System Running Louder Than Normal

A healthy tankless unit should operate with a relatively quiet, steady hum while hot water is running somewhere in the house. If your unit starts making a loud whining, groaning, or rumbling sound, it is crying out for professional maintenance. Rumbling is actually the sound of water boiling violently against a thick, rock-hard layer of calcium scale inside the heat exchanger.

Whining noises typically indicate that the combustion fan is struggling to pull in enough fresh air through a dust-clogged intake screen. Both of these unsettling noises indicate that the system is straining under extreme physical stress. The excess heat generated by this strain can easily warp metal components and melt sensitive internal wiring.

What is Causing Your Tankless Water Heater Problems

Severe Calcium and Mineral Scaling

When water is flash-heated to high temperatures inside a tankless heat exchanger, the dissolved minerals rapidly precipitate out of the liquid and bake onto the metal surfaces. The water supply in Cave Creek is exceptionally hard, meaning it carries heavy concentrations of calcium and magnesium. Without a dedicated water softening system treating the water first, a tankless unit here can accumulate a damaging amount of scale in less than a year of normal use.

Fixing this requires a professional descaling flush using specialized equipment. We connect a heavy-duty pump to the unit's isolation valves and circulate a commercial-grade descaling solution through the heat exchanger. This strong, eco-friendly acid mix runs continuously for nearly an hour to safely dissolve the rock-hard buildup and restore normal water flow.

Blocked Air Intakes and Exhaust Vents

Your tankless unit needs a massive amount of oxygen to burn gas efficiently, and it needs a clear pathway to safely vent the hazardous exhaust gases outside. Many homes in this area have their tankless units mounted on exterior walls where they are exposed to the elements. Desert winds, heavy dust storms, and local landscaping debris can easily clog the fine mesh air intake screens on these outdoor units.

When the unit suffocates, the flame burns poorly, creating excess soot that further clogs the internal components. During a proper tune-up, we disassemble the outer housing to carefully clean the intake screens and the combustion fan. We also clear out any nesting materials, cobwebs, or debris from the exhaust venting to ensure the unit is breathing perfectly.

Igniter or Flame Rod Fouling

The metal rods responsible for sparking the gas and monitoring the flame sit directly inside the harsh environment of the combustion chamber. High usage combined with dusty ambient air can significantly accelerate carbon tracking and oxidation on these highly sensitive electronic components. If the flame rod becomes coated in carbon, it cannot accurately sense the fire, causing the computer to shut down the gas valve as a safety precaution.

Restoring these components requires a delicate touch and an understanding of the internal electronics. We remove the burner assembly cover, inspect the rods closely, and gently clean off any oxidation with a specialized abrasive pad. Afterward, we test the microamp readings with a multimeter to guarantee the computer is getting a strong, reliable signal from the flame rod.

What to Expect During Your Tankless Tune-Up

Comprehensive Diagnostic and Descaling

When you call Gold Star Plumbing & Drain for a tune-up, you are not just getting a quick wipe-down of your exterior housing. We perform a highly detailed diagnostic and cleaning process designed to restore your system to factory performance levels. First, our technicians verify that your unit has the proper isolation valves installed, as these are absolutely required to perform a safe and effective flush.

We then shut off the fuel and water supply before connecting our specialized flush kit to the system. We circulate an eco-friendly descaling solution through the internal piping for forty-five to sixty minutes to melt away the stubborn hard water scale. While the pump does the heavy lifting, we pull and clean the inline water filter to remove trapped sand and sediment.

Inspection of Critical Components

While the heat exchanger is being descaled, we turn our attention to the mechanical and electronic components of the heater. We inspect the air intake and exhaust vents for any heavy desert dust buildup that might be choking the system. We also check the internal flame rods, the combustion fan, and the gas valve to ensure they are operating within safe manufacturer parameters.

Once the descaling flush is complete, we run clean water through the entire system to neutralize any remaining acid. We fire the unit back up, test the temperature output, and verify that your hot water flow rate has been fully restored. Every service is performed under the master plumber license of our owner, Mike Smith, ensuring the highest standard of care for your home.

Professional Guidance and Options

We believe in empowering our customers with knowledge about their plumbing systems rather than pushing unnecessary products. If we spot any worn components or signs of impending failure during our inspection, we will show you exactly what we found. We always provide Three Clear Options for moving forward, allowing you to choose the best path for your home and budget.

You will never experience high-pressure sales tactics from our technicians. Our goal is simply to educate you on the condition of your equipment and provide professional solutions to keep your hot water flowing. We handle everything with transparency, respect for your property, and a commitment to doing the job right the first time.

Related Services You May Need

If your tankless unit is scaling up rapidly and requiring frequent flushes, the most effective long-term solution is treating the water before it ever reaches the heater. We highly recommend looking into our Water Softener Installation & Replacement services to protect your entire plumbing infrastructure from hard water damage. If during our maintenance visit we discover that scale has already cracked the heat exchanger or ruined the flow sensor, our technicians are fully equipped to seamlessly transition into Tankless Water Heater Repair & Service to get your hot water restored.

Why Ignoring Maintenance Costs You Money

Voided Warranties and Plummeting Efficiency

Ignoring routine maintenance on a tankless water heater is one of the most expensive plumbing mistakes a homeowner can make. Almost all major tankless manufacturers explicitly require annual professional flushing in their user manuals. If your heat exchanger fails and the manufacturer discovers the unit is full of scale, they will immediately void the warranty, leaving you on the hook for the full cost of a replacement.

Beyond warranty issues, skipping maintenance directly impacts your monthly utility bills. A scaled-up unit has to burn significantly more gas to heat water through a thick layer of rock-hard calcium. You will end up paying much more for your energy usage while experiencing much worse performance at your faucets.

The Risk of Catastrophic Failure

Calcium scale does not just block water flow; it acts as an intense insulator that traps heat against the metal. This localized boiling causes the thin copper or stainless steel walls of the heat exchanger to warp and weaken under the extreme temperature differences. Eventually, the stressed metal will crack, allowing pressurized water to spray directly into the combustion chamber.

When a heat exchanger cracks, it typically floods the internal computer board and shorts out the expensive electronics. At this point, the unit is completely destroyed and cannot be salvaged. A simple, routine maintenance visit prevents this disastrous chain reaction and easily extends the life of your equipment by many years.

Schedule Your Tankless Tune-Up Today

Do not wait for your hot water to disappear in the middle of a shower or for an error code to leave you out in the cold. Routine maintenance is the absolute key to keeping your system running efficiently, safely, and reliably for over a decade. As an independent, family-owned company, we are dedicated to providing Cave Creek residents with honest, high-quality service backed by industry-leading warranty options ranging from a two-year minimum up to lifetime parts and labor. We offer same-day service availability to ensure your plumbing needs are met on your schedule. Contact Gold Star Plumbing & Drain today to book your tankless water heater maintenance and experience the gold standard in plumbing.

Tell us what it is doing.

Submit your request and a member of the Gold Star team will call you as soon as possible to answer your questions and schedule your service. If water is moving right now, call instead. A person answers.

Hours
Open 24 hours, seven days
Licence
Arizona ROC 327327

Book a time online

Pick a slot and it is a confirmed appointment, not a request.

Rather talk it through? Call (480) 571-5944 — a person answers, every hour of every day.

Or tell us what is going on

Send it through and a member of the Gold Star team will call you back to answer your questions and schedule the work.

Request Your Service

Submit your request and a member of the Gold Star team will call you as soon as possible to answer your questions and schedule your service. Need help now? Call: emergency plumbers are dispatched 24/7.

Loading form. If it does not load, please use the other contact options on this page.

How we use your information: Privacy Policy · Your Privacy Choices

Call now Book online