Skip to content
East Valley (480) 571-5944 · Northern AZ (928) 813-0825 · Open 24 hours, seven days. $300 off tankless water heater installation → · Finance now →

Symptom Center

Burst Pipe? Shut Off the Water First, Then Call a Plumber

Shut off the main, stay clear of electricity near water, and call. An active leak is an emergency.

Call now An active water leak is a defined plumbing emergency, and every minute the water runs adds to the damage.

Call (480) 571-5944

Symptom Center · 4 min read

By Mike Smith , Owner, Gold Star Plumbing & Drain · LinkedIn

Water spraying from a wall, pouring through a ceiling or flooding from under a sink needs action before anything else. The first job is not finding the pipe. It is stopping the water. Then you make the area safe and call.

Gold Star treats active water leaks as a defined plumbing emergency. Emergency technicians are dispatched 24/7, and a live, in-house call taker answers after hours. Once things are under control, take a few minutes to read what to do before the plumber arrives so you know where your valves are before you need them again.

What should I do the moment a pipe bursts?

Shut off the main water valve, switch off power to any wet area if you can reach the panel safely, then open a low faucet to drain the lines.

In most Arizona homes the main shutoff is outside, on the pipe that rises from the ground near the front hose bib. Turn the wheel clockwise, or turn the lever a quarter turn. If the burst is at a single fixture, such as a toilet or sink supply line, the small shutoff valve under that fixture may be enough.

Water and electricity do not mix. If water is near outlets, appliances or a ceiling light, switch off those circuits at the breaker panel, but only if you can reach the panel without standing in water. If you cannot, stay out of the area.

Once the main is off, open a faucet at the lowest point in the house and an outside hose bib to drain the water left in the lines. Move rugs, furniture and boxes out of the water, and photograph everything for your insurance carrier.

  • Main water shutoff off
  • Power off to wet areas, only if the panel is dry and safe to reach
  • A low faucet and an outside hose bib open to drain the lines
  • Belongings moved and photos taken
  • Then call a plumber

Why do pipes burst?

Freezing in the high country, failed supply lines and hoses, corrosion, and water pressure higher than the plumbing was built for.

In Flagstaff, Prescott and the Verde Valley, water left in a pipe on a cold night can freeze, expand and split the pipe. The leak often shows up when the ice thaws. Our guide to frozen pipes in Northern Arizona covers prevention.

In the Valley, the more common causes are a failed braided supply line at a toilet, sink or washing machine, a corroded fitting, or a pinhole that finally gives way. High water pressure adds stress to every part of the system, and a failed pressure-reducing valve can let it climb.

What does the plumber check first?

We find the failed section, check the pipe around it, and measure water pressure so the repair is not followed by another burst.

We start by finding exactly what failed: a supply line, a fitting or a section of pipe. Then we look at the pipe around it. One bad spot on otherwise healthy pipe is a repair. Corrosion along the whole run means more failures are likely.

We also check static pressure at a hose bib, because pressure above what the plumbing was built for is a common reason pipes and hoses fail. Gold Star aims to arrive within two hours for emergency calls, or as soon as possible depending on location, technician availability, and current demand.

How is a burst pipe repaired?

A single failure is repaired in place with new pipe. Repeated failures or widespread corrosion usually call for replacing the affected lines.

A pipe leak repair replaces the failed section, usually with copper or PEX-A. If the pipe is behind a wall or ceiling, a small opening is needed to reach it. Patching that opening and drying out the wall or floor are separate jobs from the plumbing repair, and your insurance carrier can explain how that part works under your policy.

If the house has had more than one leak, or the pipe is corroded along its length, a repipe may be the lasting fix. Our guide to signs you need repiping covers when that makes sense. Three Clear Options. No Pressure. You approve the option and its upfront price before any work begins, and Financing Options Available through GreenSky for larger work.

Quick answers

I can't find my main shutoff. What do I do?
Look outside near the front hose bib for a pipe rising from the ground with a wheel or lever on it. If you still cannot find it, the water utility can shut off water at the meter. Then call us.
What does an after-hours emergency visit cost?
The after-hours and emergency service fee is $129. It covers dispatching the plumber, diagnosing the problem and presenting your repair options. The repair itself is priced upfront, and you approve it before work begins.
Should I turn the water back on to see if it stopped?
No. Each test adds more water to the damage. Leave the main off until the plumber has repaired the pipe.

Next step

Water off and the area safe? Call us next. Emergency technicians are dispatched 24/7.

Reach us now
Call now Book online