Step 01 · Learn · 4 min read
By Mike Smith
, Owner, Gold Star Plumbing & Drain ·
LinkedIn
Every house gets the occasional leak. A house that keeps getting them is telling you something different: the pipe itself is wearing out, and patching one spot at a time just moves the next leak somewhere else.
Repiping replaces the water supply lines throughout the house. It is a big job, so it is worth knowing the signs that point to it, and the ones that do not.
What are the signs a house needs repiping?
Repeat leaks in different places, an old pipe material known for problems, water pressure that keeps dropping, and discolored water from more than one tap.
One sign on its own is rarely enough. A single leak from a nail through a pipe is a repair. Several leaks over a few years, in different rooms, on pipe of the same age, is a pattern. The same goes for pressure and water color: one fixture acting up is usually that fixture, while the whole house acting up points to the pipe.
- Pinhole leaks that keep showing up in different spots
- Galvanized steel or polybutylene supply pipe
- Water pressure that has dropped across the whole house
- Rusty, brown or yellow water from several taps
- More than one slab leak
Why do pinhole leaks keep coming back?
Because the pipe is wearing thin from the inside everywhere at once. Fixing one pinhole does not change the condition of the rest of the line.
Copper pipe can pit over time, especially with hard water, high water velocity, high pressure or aggressive water chemistry. Tiny pits grow until one breaks through as a pinhole leak, often a spray or drip inside a wall or ceiling. Under the floor, the same thing becomes a slab leak.
The first pinhole is a repair. By the third or fourth, the repeat repairs, plus the drywall and flooring each one disturbs, are worth weighing against replacing the pipe once. If yours are under the floor, our slab leak guide covers repair versus reroute, which is often where the repiping conversation starts.
Which kinds of old pipe are the usual suspects?
Galvanized steel and polybutylene. Both were common in homes of their era, and both are known to fail with age.
Galvanized pipe is steel with a zinc coating, found in older homes built before copper and plastic took over. Over decades the inside rusts and narrows with corrosion and mineral buildup, so pressure drops and the water can run brown. It usually looks dull gray and has threaded fittings where the pieces screw together.
Polybutylene is a flexible plastic pipe, often gray, used in many homes built from the late 1970s into the mid 1990s. It can turn brittle and crack from the inside with age and exposure to treated water, sometimes with no warning. If you are not sure what you have, look where pipes come out of the wall under sinks and at the water heater, or ask a plumber to identify it during a visit.
What do low pressure and discolored water tell you?
When they show up at every tap, they often point to the pipe itself narrowing or corroding, not to a fixture.
Start by ruling out the simple causes on our low water pressure and discolored or smelly water pages. A clogged aerator, a partly closed valve or city work in the street can all mimic a pipe problem. Rust in only the hot water often points to the water heater rather than the pipes.
When the cause is not something simple, and pressure keeps falling or rusty water keeps returning from several taps, the supply pipe is the likely source. That is especially true in a house with galvanized pipe, where the inside of the pipe slowly closes up.
What does repiping involve, and what is it done with?
New supply lines are run through the walls and attic to each fixture, then the old pipe is disconnected. Gold Star repipes with copper and PEX-A.
Repiping is planned work, not demolition. Plumbers open small access points in walls or ceilings, run the new lines, connect each fixture and test the system. Most of the old pipe, including runs under the slab, is left in place and disconnected. Repiping and water-line replacement are core Gold Star services, and our repiping and pipe replacement page explains how the job is handled.
Copper is rigid, long proven and handles heat well. PEX-A is flexible, needs fewer fittings and is more forgiving of freezing than rigid pipe. Our copper vs. PEX vs. PVC guide compares them. Industry-Leading Warranty Options—from a Two-Year Minimum up to Lifetime Parts and Labor. Terms vary by service and option and are explained before work begins. Financing Options Available through GreenSky.
Quick answers
- Another company told me I need a full repipe. Can you check?
- Yes. Get a Free Second Opinion—No Competitor Paperwork Required. Gold Star can provide free estimates and second opinions on qualifying work. A Gold Star team member will confirm eligibility. Diagnostic/service fees may apply when troubleshooting is required.
- Is repiping the same as replacing the water line?
- No. Repiping covers the supply lines inside the house. The water line is the pipe that runs underground from the meter to the house. They can wear out together and a plumber can check both, but they are separate jobs.
Next step
Repiping