Step 02 · Evaluate · 4 min read
By Mike Smith
, Owner, Gold Star Plumbing & Drain ·
LinkedIn
Hearing that your sewer line needs repair usually brings one picture to mind: a trench across the front yard. Sometimes that is still the right answer. Often there is another option that fixes the pipe from the inside.
Here is how trenchless repair and traditional excavation compare, and how a camera inspection decides which one your line can actually use.
What is the difference between trenchless repair and dig and replace?
Trenchless repair fixes the pipe from the inside through small access points. Dig and replace opens a trench so the damaged pipe can be removed and new pipe laid in.
Trenchless lining feeds a resin-soaked liner into the old pipe and cures it in place, forming a new, seamless pipe inside the old one. The work happens through a cleanout or a small access pit, so most of the yard stays as it was.
Dig and replace is the traditional method: excavate down to the pipe, cut out the damaged section, lay new pipe at the correct slope, and backfill. Between the two sits a sewer spot repair, which digs only where one section has failed.
How does a camera inspection decide it?
The camera shows the pipe's shape, the type of damage and where along the line it sits, and those facts decide which methods can work.
A sewer camera inspection travels the line and records what is inside: cracks, roots at the joints, offset joints, low spots holding water, or a section that has collapsed. Our guide to sewer camera inspections explains what the footage shows.
The line often has to be cleaned first, sometimes with hydro jetting, so the camera and any liner have clean pipe to work with. This guide picks up where our drain cleaning methods guide leaves off: once the camera shows damage rather than a simple clog.
When does trenchless lining fit?
When the pipe still holds its shape and slope: cracks, roots at the joints, corrosion and leaking joints along a line that is still round and draining in the right direction.
A cured liner has no joints along its length, and joints are where roots usually find their way in. Because it goes in through small access points, lining can avoid tearing up driveways, pavers, desert landscaping and other features many Arizona yards are built around.
Our trenchless sewer repair page covers how the work is done and what to expect on the day.
When is digging the better answer?
When the pipe has collapsed, sags enough to hold water, has badly offset joints, or needs its slope corrected, because a liner follows the shape of the pipe it is placed in.
A liner cannot fix a belly in the line. If a section has settled and holds water, lining it leaves the low spot in place, and waste keeps collecting there. A collapsed pipe may not leave room for a liner at all.
In those cases, excavation and underground repair lets the plumber remove the bad pipe and lay new pipe at the correct slope. When the whole line is failing, full sewer line replacement may be the long-term answer.
How do I weigh the options once I have the footage?
Ask the plumber to show you the damage, explain which methods could work on your line, and lay out each option with its warranty.
Gold Star offers Three Clear Options. No Pressure. Whenever possible, you will see more than one way forward, with the benefits and warranty coverage of each explained before you choose. Sewer work often needs a permit and an inspection, which an honest plan includes from the start.
Sewer repairs can be a big expense, and Financing Options Available through GreenSky can help. Our guide to financing vs. paying cash walks through that decision.
Quick answers
- Does trenchless mean no digging at all?
- Usually it means very little. The work is done through an existing cleanout or a small access pit rather than a trench along the whole line.
- Will lining make my pipe smaller?
- A liner takes up a little room inside the pipe. On a sound residential line, the plumber will confirm it still drains properly before recommending it.
- Can roots grow back through a liner?
- A cured liner has no joints along its length, and joints are where roots usually get in. That is one of the main reasons lining is used on root-damaged lines.
Next step
Sewer line services