Skip to content
East Valley (480) 571-5944 · Northern AZ (928) 813-0825 · Open 24 hours, seven days. $300 off tankless water heater installation → · Finance now →

Learn · Learning Center

How to Spot a Hidden Water Leak: The Meter Test Explained

The early warning signs, and a ten-minute test you can run with the lid of your meter box.

Step 01 · Learn · 5 min read

By Mike Smith , Owner, Gold Star Plumbing & Drain · LinkedIn

A burst pipe announces itself. A hidden leak does not. It runs quietly inside a wall or under the slab for weeks or months, wasting water the whole time and, in the worst cases, softening the ground under your foundation.

The good news: your water meter is a leak detector you already own, and reading it takes about ten minutes. Here is what to watch for, and exactly how to run the test.

What are the early signs of a hidden leak?

A water bill that climbs without a reason, warm spots on the floor, the sound of running water when everything is off, and musty smells or new cracks near baseboards.

No single sign proves a leak, but they stack. A hot-side slab leak often shows up as a patch of tile or concrete that feels warm underfoot, because hot water is running under it around the clock — many homeowners first notice it barefoot in the kitchen. A cold-side leak is sneakier; the bill and the meter are usually how it gets caught.

Listen at night. With the house quiet and every fixture off, put your ear near a wall with plumbing in it. A faint hiss or trickle you cannot explain is worth investigating. Mold smell in one room, a water stain that comes back after you paint over it, or a door that suddenly sticks can all point the same direction.

How do I run the meter test?

Turn off every fixture and appliance that uses water, then watch the meter: if it still turns, water is leaving the system somewhere.

Your meter is usually in a rectangular box in the ground near the street or sidewalk. Lift the lid — carefully, spiders like meter boxes in Arizona — and find the dial. Most Valley meters have a small red, blue or star-shaped low-flow indicator that spins with even a trickle.

  • Make sure no water is running: faucets, appliances, ice maker, evaporative cooler, pool autofill and irrigation all off.
  • Photograph the meter reading, including the low-flow indicator's position.
  • Wait 30 to 60 minutes without using any water.
  • Photograph it again. Any movement means water flowed while everything was off.
  • To split house from yard: close the house-side shutoff valve and repeat. If the meter still moves with the house valve closed, the leak is in the yard line or irrigation; if it stops, the leak is inside the house.

What does it mean if the meter moved?

Something on your side of the meter is leaking. The test proves the leak exists; finding it is a locating job, not a digging job.

First rule out the honest suspects: a running toilet can move a meter all day and is a cheap toilet repair, and a stuck water softener or a pool autofill valve can do the same. Drop food coloring in each toilet tank; if color reaches the bowl without a flush, you have found at least one culprit.

If the suspects check out and the meter still turns, the leak is hiding. This is where professional leak detection earns its keep: we isolate sections of the system to prove where the loss is, then locate the leak with specialized leak locating equipment so the repair opens one small spot instead of a trench through your kitchen. Those two meter photos you took, with the time between them, genuinely help the tech — bring them up when you call.

Why are slab leaks so common in Arizona?

Most Valley homes run copper lines under a concrete slab, and our soil, water chemistry and temperature swings work on that copper year after year.

Post-war Arizona construction put water lines under the slab instead of in a basement, because there are no basements. Copper in contact with reactive desert soil can pit from the outside; hard, hot water moving fast through the pipe erodes it from the inside; and the slab itself expands and contracts through our summer-to-winter swings, flexing every line under it.

A pinhole in a hot line under the slab is the classic result. Caught early, it is a locate-and-repair job. Left to run, it can undermine the soil under the foundation, which is a much bigger conversation. That is the whole case for the meter test: it turns "I wonder" into an answer before the damage compounds. If the test points under the slab, our slab leak repair page explains what happens next.

Quick answers

My bill jumped but the meter test shows nothing. What gives?
Intermittent users are the usual answer: irrigation running longer than you think, a pool autofill topping up a leaking pool, or a toilet that only runs occasionally. Re-run the test at a different time of day, and check the irrigation controller before assuming the meter lied.
Is a slab leak an emergency?
It is urgent, not usually a middle-of-the-night emergency. Same-day attention is the right speed: the leak is wasting water constantly and can be soaking soil under the foundation, but a functioning house does not need to be shut down at 2 a.m. unless water is actively surfacing.
Should I just shut off the water until someone can look?
If the meter shows heavy movement or you can see water surfacing, yes — close the main house shutoff and run the test results past a plumber the same day. For a slow leak, normal life can continue while you book the visit.

Next step

If your meter moved with everything off, the next step is locating the leak precisely — before it gets to pick the repair date.

Leak detection

More in understand your plumbing

All guides →
  1. How Arizona Hard Water Destroys Fixtures and Water Heaters Why fixtures crust over and water heaters fail years early in the Valley. 5 min
  2. Anode Rods: Why Arizona Water Heaters Die Early Without One The sacrificial part inside your tank, and the reason heaters here quit ahead of schedule. 4 min
  3. Signs You Need a Plumber: When to Call and When to Watch The everyday warning signs, sorted into call now, book soon and watch for now. 5 min
  4. How Drains and Sewer Lines Work in an Arizona House From the trap under the sink to the city sewer, and what a backup is telling you. 5 min
  5. Types of Water Heaters: Tank, Tankless, Hybrid and More How tank, tankless, heat-pump and recirculation setups each make hot water. 5 min
  6. Slab Leaks in Arizona Homes: Signs, Causes and Repair What a slab leak is, how it gets found, and spot repair versus rerouting the line. 5 min
  7. How Long Water Heaters Last in Arizona and How to Extend It What shortens a heater's life here, what stretches it, and how to replace on your schedule. 5 min
  8. Frozen Pipes in Flagstaff, Prescott and the High Country Why high-country pipes freeze, how to protect them, and what to do if one splits. 5 min
  9. Sewer Camera Inspections: How They Work and What They Find What the camera sees in your sewer line, and the moments when a look is worth it. 4 min
  10. Signs Your House Needs Repiping: Leaks, Pressure, Old Pipe The patterns that point to worn-out pipe, and what a repipe with copper or PEX-A involves. 4 min
Call now Book online