Step 01 · Learn · 5 min read
By Mike Smith
, Owner, Gold Star Plumbing & Drain ·
LinkedIn
Water comes into your house under pressure. It leaves by gravity. That one difference explains most of how drains behave, why they clog where they do, and why a backup in the tub can start with a problem out by the street.
Here is a plain tour of the drain and sewer system in a typical Arizona home, from the trap under your sink to the point where your line meets the city's, so a slow drain or a backup makes sense the moment it happens.
How does water leave the house?
By gravity. Every drain pipe slopes slightly downhill, and the branch lines from each fixture join larger lines that all lead to one main sewer line.
Your supply pipes are small and pressurized, so water in them can go uphill, around corners and through the attic. Drain pipes have no pressure behind them. They are larger, and each one is laid at a gentle downward slope so waste keeps moving. Too little slope and solids settle. A sag in the line, called a belly, holds water and debris in one spot.
Most Arizona homes sit on a concrete slab, so the drain lines run underneath it. Sinks, tubs and toilets each drain into a branch line, the branch lines join under the floor, and the combined flow leaves the house through one main line. Newer homes typically use ABS plastic drain pipe. Older homes may have cast iron under the slab and clay pipe out in the yard.
What do traps and vents do?
A trap holds a small plug of water that blocks sewer gas. Vents let air into the system so water drains smoothly and the traps stay full.
The U-shaped bend under every sink is a trap. The water that stays in the bend seals the drain so sewer gas cannot come back into the room. Tubs, showers and floor drains have traps too, and toilets have one built into the bowl. A sewer smell from a drain that rarely gets used, like a guest shower, is often just a trap that dried out. Running water for a minute refills it.
Vents are the pipes you see poking up through the roof. They let air in behind the draining water. Without that air, draining water pulls a vacuum that can siphon a trap dry, and fixtures gurgle and drain slowly. A gurgle in one fixture when another one drains can be a vent problem, or the first sign of a clog farther down the line.
What is the main line, and where is the cleanout?
The main line is the one pipe that carries everything out of the house. The cleanout is a capped opening on it, usually outside near the foundation, that gives a plumber a way in.
Because every fixture ends up in the main line, a clog there affects the whole house at once. That is why several slow drains at the same time point to the main, and why one slow sink almost never does. Our all drains slow page walks through that pattern.
The cleanout is usually a short pipe with a threaded cap, sticking a few inches out of the ground near the front or side of the house. Plumbers use it to run a cable, a hydro jetting hose or a camera into the main without pulling a toilet. It is worth finding yours now and keeping it clear of rocks, gravel and plants.
Where does my line meet the city sewer?
Your main line runs out under the yard to a connection with the city sewer main, usually under the street or an alley. That stretch of pipe is called the lateral.
The lateral is the part most homeowners never think about, and it is often the oldest pipe on the property. Tree and shrub roots looking for water find their way into small gaps at its joints. Clay pipe can crack, and ground movement can shift sections out of line. Problems out there show up inside the house first, as slow drains and backups at the lowest fixtures.
In many cities the homeowner is responsible for the lateral from the house to the connection, and the city is responsible for the main. The exact dividing line varies, so it is worth checking with yours. Either way, a sewer camera inspection shows which side of that line a problem sits on.
So what does a backup actually mean?
It means water cannot get past a blockage, so it comes back up through the lowest open drain. Where it shows up tells you roughly where the blockage is.
Water takes the easiest way out. If the main line is blocked, the lowest drains in the house, usually a tub, shower or floor drain, are where it comes back up. Flushing a toilet and seeing water rise in the tub is the classic sign. A backup in one sink only, with everything else draining fine, is a branch line clog and a much smaller job.
Sewage coming back into the house is one of the two situations Gold Star treats as a plumbing emergency. Stop using all water, keep people and pets away from it, and read what to do about a sewage backup. Once the line is open, the next question is why it blocked. Our drain cleaning methods guide covers how a plumber chooses between snaking, jetting and a camera.
Quick answers
- Why does my toilet gurgle when the washer drains?
- The draining water is pulling air from wherever it can, and the toilet is giving it up. That usually means a partial clog in a shared line or the main, or a blocked vent. If the gurgle is new, have it checked before it turns into a backup.
- Can I pour drain cleaner down the cleanout?
- No. Chemical openers rarely clear a main-line blockage, and they sit in the pipe until someone has to open it. If the main is blocked, leave the cleanout capped and call.
- Do newer homes have fewer drain problems?
- They have fewer old-pipe problems like cracked clay and rusted cast iron. They still clog from grease, wipes and hair, and a newer line can still sag if the soil under it settles.
Next step
Sewer line services